Extra long shades

Our workroom has standard 8' drop ceilings.  I had an order for 4 shades 42" wide and 99" long.  Since the shades were being shipped to Florida, I was not going to be at the installation, so I had to find a way to hang them.  Enter John: he took out a 48" ceiling panel, extended our hydraulic stand, and we raised them up into the ceiling so I could level them!

 

Not only were these shades long; they also were blackout lined with my no-pinholes method and ribs; and because circumstances necessitated mounting them on the molding, they also needed to be reverse mounted with a valance.  I used my standard no-pinholes method with ribs, which means working from the inside of the shade.  The combination of Bella Notte Duette (bonded with flannel) and Bella Notte Silky blackout makes a very handsome and substantial shade.

My favorite lift system for a reverse mount is a system such as Rowley's EZ-Rig, whose headrail comes with velcro on one side.  The shade goes on the back of the headrail so it will be snug up against the window molding and let less light in the sides.

I hand-basted the layers together at the top, then fused Dofix velcro to the face.  I did worry because of the weight so I took the totally completed shade to the machine and sewed the velcro for extra security.  This was a little awkward because the ribs and weight bar were sewn inside the shade, but since they were only 42" wide I managed it.

I left the basting stitches in and I left the raw edges- blackout linings don't fray, and the fused velcro hid the face fabric raw edges.

Each lift line needed a grommet for the cord to pass through to the front.  They need to go as high up as possible without causing any buckling; I usually put them about 6" below the top.

 

The shades were strung using Ring Locks from SafeTShade in order to be compliant with the safety standards.

I wasn't sure how long the valance would need to be to cover the grommets.  After the headrails were mounted on the boards we raised one up with a piece of paper taped to it to see how long to make the valances.  

The self-lined valances had to go 1" farther back than the board, so they would reach the wall.  I wanted to fit them with velcro to make the underneath more accessible for the installer, so I mitered the corners of the valances and added Dofix fusible velcro.

That is sweet!

Regular hook velcro from Rowley was stapled to the back edge of the board.

 

They fit beautifully and the installer's job was easier since he could peel back the corners to hang the shade.

 

Eventually I hope I'll receive photos of the installed shades, but for now, a table shot will have to do.